Home >> News Center >> Industry News >> Characteristics of tapered roller bearing

  Tapered roller bearings, due to the lateral position of the rolling element (cone) cancapture in rolling mill as well as axial and radial forces, double row of four-row tapered roller bearings. Tapered roller bearings are separable; inner and outer rings can be installed separately. If the tapered roller bearing in high speed, high load, the inner ring should be fixed firmly. In this case, bearings with a tapered bore and magazine fitted to a cone. Thank you, the inner loop location is very easy to achieve required. Double row spherical roller bearings have two rows of ordinary spherical roller of spherical orbital ring. This design allows mutual tilting ring. They can transfer agreat deal of radial and axial loads in both directions. Cylindrical and tapered bore bearings manufacture. These bearings are suitable locations and tipability large loads, you must ensure that movements and axial misplacement of bearings can be removed. These bearings can be used in low and medium revolutions. Scrolling speed is not more than 12 m/s.

  Horizontal split of rolling bearings, especially in the structure of production-proven technology and the production of cylindrical roller bearings and spherical roller bearing to his outer diameter 1600 mm. Classification of these bearings is expanding, and manufacturers in the world. Horizontal split bearings and benefit mainly uses in the axial component of the bearing position is impossible, this is the situation in the shaft, crankshaft or long transmissions, or installing a bearing is too long, and long long closure caused the operation to fail. Most common horizontal split bearings in theworld is single row cylindrical roller double row spherical roller bearings. The production plans of the buildings included in the production. Radial bearing features divided into the outer ring, guide ring and rolling element within the cage. Cages are usually compact, brass. Connected to resist the dynamic parts of the cage, cages exposed to the army during the operation. Ring in two parts through a belt loop is equipped with threaded connection to prevent loosening. Between the inner ring of the ringbefore the line can be vertical. Instead, the dividing line between inner ring is tiltedangle, down stroke on the rolling elements roll on the edge of the load line of the zone.


Previous: How to determine the life of the bearing system

Next: What are bearing